Hondata Coil Pack Retrofit Kit for B/D/H/F Engines with S300.

Starting at: $395.00

**NOW BACK IN STOCK!!**

Hondata Coil Pack Retrofit (CPR)

$20 Discount on CNC machined distributor cover with purchase!

Overview The Hondata Coil Pack Retrofit (CPR) allows the use of 'coil on plug' individual ignition coils on engines with distributor based ignition systems (D, B, F and H series Honda engines). It does this by replacing the stock coil and ignition with an electronic circuit which can drive igniter type individual ignition coils, such as used on later model Honda engines. A Hondata S300 system is required.

How much does the Hondata CPR cost? $395

What does the Hondata CDR come with?
The Hondata CPR comes with a wiring harness for your coil packs, a coil pack controller and fly leads for connecting to your distributor and ECU. The CPR is typically positioned next to the ECU inside the car.

Benefits
* More spark energy than a single coil, allowing a larger plug gap and fewer misfires. * Individual coils are more durable and less likely to fail than the stock igniter and coil. * No exposed plug leads results in less interference to other electronics on the vehicle. * Additionally, the Coil Pack Retrofit can drive a CDI controller if desired.

Requirements
* Hondata S300 system (not included). * 4 x coils, Honda part number 30520-PVF-A01 (approx $60 retail and not included)

Optional parts
* 4 x coil seals, Honda part number 30522-RNA-A01 (approx $19 retail)

These coil seals provide a tighter fit than those supplied with the 30520-PVF-A01 coils.

Notes
* Resistor plugs must be used.
* The coils require a method of retention. B16A, B18C & F22A engines may use the stock plug cover. Other engines require an alternative method of coil retention (not supplied).
* This is a race product. Cranking times may be increased over a stock ignition set up.
* For detailed installation instructions see the link below.

http://www.hondata.com/help/cpr/index.html

FAQ
- Can I remove the distributor?
No. It is needed for the timing signals. See the CPR help file for more details.

CDI
- The Coil Pack Retrofit can be used with capacitive discharge ignition systems, such as M&W Pro-14, Autronic 500R or Motec 41011. Note that a CDI controller must be used - the Coil Pack Retrofit will not drive capacitive coils directly.
The CDI controller will be triggered from the Coil Pack Retrofit coil trigger outputs. The Coil Pack Retrofit produces a rising edge trigger for the coil packs, so the CDI controller should be configured to use a rising edge trigger.

Does this sytem work with any other engine management?
NOT AT THIS TIME. At this time ONLY hondata s300 works with it.
"The S300 needs to output a synchronization signal to the coil driver." The system communicates with the ALTC (alternator control) output.

Add to Cart:

  • Manufactured by: Hondata

Please Choose:




 
Your IP Address is: 18.206.16.123
Locash Racing, LLC
2853 S. 44th St. #102
Phoenix, AZ 85040
602-763-5189
Copyright © 2019 Locash Racing.
Powered by Locash Racing